LC10P Series AC Servo Driver

Product Overview

The servo system mainly consists of three parts: the controller, the power drive device, the feedback device, and the motor. The controller adjusts the control quantity based on the difference between the given value from the numerical control system and the actual operating value detected by the feedback device; the power drive device acts as the main circuit of the system, on one hand applying electrical energy from the power grid to the motor according to the control quantity to regulate the motor torque, and on the other hand converting the constant voltage and frequency power supply from the grid into the AC or DC power required by the motor; the motor drives the mechanical operation according to the supplied power.

Features

Compatible with servo motors from 0.05KW to 1KW Supports 7 control modes / Frequency division feedback function Supports 48 bus, CANopen bus Supports 17bit/23bit servo motors Supports self-learning function, can be adapted to motors of various brands in market

Product Overview Supporting Products Data Download

Driver Specifications

Input Power	Single-phase 220VAC
Operating Environment	Temperature	0~45 ℃
	Humidity	≤90%RH without condensation
	Altitude	Altitude ≤1000mm
	Installation Environment	No corrosive gases, flammable gases, oil mist, or dust
	Installation Method	Vertical installation
Encoder		Supports 17-bit incremental/absolute encoder, 23-bit incremental/absolute encoder
Control Signals	Digital Inputs	8 general digital inputs, configurable functions.
Control Signals	Digital Outputs	6 digital outputs, configurable functions.
Pulse Signals	Input	2 high-speed inputs: supports up to 1MHz pulses, 50% duty cycle. Supports pulse input modes: PULS+DIR, A+B, CW+CCW.
Pulse Signals	Output	3 high-speed pulse outputs, output signal form: 5V differential signal. 1 Z signal single-ended output.
Analog Signals	Input	2 analog inputs, 12-bit resolution, input range -9.5 to +9.5V. AI2 is fixed as torque limit input.
Analog Signals	Output	None
Communication Features		RS485 communication, ModbusRTU protocol.
Display Panel and Key Operation		5 keys (Mode, Set, Left, Up, Down) and 6 digital tubes.
Regenerative Braking Resistor		Built-in 50W 40Ω braking resistor. External braking resistor required for frequent braking scenarios.

Driver Naming Rules

MODBUS Bus Communication

The LC10P series servo driver features MODBUS bus communication, allowing servo position/speed/torque control via controllers with MODBUS functionality. Supports up to 32 control stations, greatly reducing controller costs.

Item	Specification
Communication Protocol	MODBUS RTU
Bus Connection	RJ45 (CN3, CN4)
Baud Rate	2400bps, 4800bps, 9600bps, 19200bps, 38400bps, 57600bps
Number of Stations	Up to 32 (the last station requires shorting the terminal resistor jumper)